Skip to main content

Experts for soil and floor protection

+ 49 6462 91507 0  |  sales@securatek.de
5% discount offer for the MegaTrack PRO heavy-duty road plate
Save now!

Save in November 5% when you buy our products with up to 200 t load capacity MegaTrack PRO heavy-duty road plate with fully integrated connection technology and load-distributing overlapping lips.

Slope stabilization in the garden made easy with the BM350 embankment mat

Published on September 21, 2016 by Kim Schäfer

Slope mat BMK 350 It is incredibly easy to stabilize a slope and effectively reduce soil erosion. This customer testimonial illustrates a typical application in a newly landscaped private garden. The slope lies at the transition between the patio and the garden or lawn area. To avoid losing too much garden space, a slightly steeper slope angle (gradient/gradient) is usually chosen. However, the steeper the slope, the more difficult it becomes to successfully sow seeds and establish new vegetation, plants, and grass.

It is precisely for these reasons that we recommend using our embankment mat. The BM350 embankment mat is made of 100% natural coconut fibers, quilted with PP thread in a PP mesh. If the slope is to be covered with grass seed, for example, it is recommended to sow the grass seeds onto the embankment mat and cover them with fertile soil after sowing. The grass seeds and soil are held in place by the coconut fibers of the embankment mat and are protected from wind erosion, water erosion, and soil erosion. For this reason, the embankment mat is also often called a seed mat.

If the slope is to be planted, the erosion control mat can simply be cut in a cross shape at the desired location using scissors or a knife, creating a so-called planting hole. The plant is then placed in the planting hole as usual. Once all the plants have been planted, the erosion control mat can be covered with, for example, soil, bark mulch, or wood chips. The coconut fibers in the erosion control mat improve the stability of the covering material.

Installation instructions: When installing the embankment mat, ensure that the individual panels are laid flat next to each other, perpendicular to the slope. The overlap should be approximately 10 cm at the vertical longitudinal joints and approximately 10–20 cm at the transverse joints. The open edge of the overlap must face away from the prevailing wind direction. The embankment mat should be secured in the ground with either steel ground anchors (U-shaped wire brackets) or wooden stakes, preferably made of beech, as long as no vegetation has grown.

Note on the wooden stake HPB300: The wooden stake was shortened to the appropriate length by the customer.

Note: The product solution shown for Ground reinforcement This product is no longer offered by us. For alternative solutions... We would be happy to advise you personally..

Short & concise

The features highlighted in blue lead to further suitable references.

fitting products

Downloads

Inquire directly

Request advice / offer for products in the reference
Would you like advice or a quote?
Contact us, we'll be happy to help!